PoE power supply-Shenzhen Gochen Technology Co., Ltd

PoE power supply

(1) Embedded light bar can not be installed directly on combustible objects Some families use three plywood lined with paint behind the ceiling lamp for aesthetic purposes, which is actually very dangerous and must be insulated; if the high-temperature parts of the lamp surface are close to combustible objects, insulation or heat dissipation measures should also be taken.

Category:

Power chip

LCD module, driver, logic chip, relay

Optocoupler/infrared/light emitting tube

Internet of Things/Communication Module

Diode/triode, MOS transistor, and IGBT

key word:

PoE power supply

Product Description

(1) Embedded light bar can not be installed directly on combustible objects

Some families use three plywood lined with paint behind the ceiling lamp for aesthetic purposes, which is actually very dangerous and must be insulated; if the high-temperature parts of the lamp surface are close to combustible objects, insulation or heat dissipation measures should also be taken.

(2) Wrap the connection wire well

The two wires connected to the power inlet of the recessed strip light, electrical contact should be good, but also separately wrapped with black tape, and keep a certain distance, if possible, try not to put the two wires under the same piece of metal, to avoid short circuit, the danger.

(3) Embedded light bar should also be checked before installation

The cross-section of the wire core leading to each lamp, copper-core flexible wire is not less than 0.75mm2, otherwise the lead must be replaced. The connection between the lead and the lamp head, the connection of parallel wires between lamp heads should be firm, and the electrical contact should be good, so as to avoid the danger of sparking between the lead and the terminal due to poor contact.